Hot Rods Panhard & sway bar bushings

Are all aftermarket panhard and sway bar bushings the same OD?

My old beater needs new panhard bushings and I originally purchased them from TCI over 30 years ago, I have ordered a catalog from TCI over a month ago but still haven't received it.

I don't want to wait any longer and don't want to take it off the car and have the car out of commission while I wait. HRP

 

Not in my experience.... There's also a wide range of bushing durometers available, and that can make a difference too.

 

Not even close.
No...EASY way out..! Measure what you have then go on a search.

Mike

 

Call Pete & Jakes. They had what I needed

 

I would call TCI! You are in a situation where you are agrivated as a lot of us have been also. If your bushing is polytherine I would call Pete&Jakes. They are very helpful if you have never delt with them...…..

 

Look at Energy Suspension's site. They have a section just on bushings and measurements.

 

I did call and I might as well be talking to the new kid on the parts counter a Advanced Auto parts,I couldn't get a straight answer but they said they would send a catalog and that hasn't happen.

I might just have to remove it but it sure would simplify everything if TCI had someone that knew their head from a hole in the ground.

Maybe they have been bought out by The Hoffman Group. HRP

 

After my last post I tried again and was able to talk to some one in the technical department and I have what I need coming, Thanks guys. HRP