1952-59 Ford Seat belt length

I'm going to get seat belts for the 58 Ford wagon. It has the original bench seats. Do I go with 60" or 74"?

 

Not sure you could go wrong with the longer belts, on the other hand..........
Folks in general are a lot fatter than they were in the 50's, so shorter belts may be a problem?? But, if your 6'5" with a 30" waist, the short belts should be just fine.

 

Go with the longer ones! I bought and installed the shorter ones, and they are too tight. I have a 37 inch waist on a 6'2" frame, and they are too tight.

 

Same here, 60" belts just barely able to snap them, wish I had bought the longer.

 

I went 74" with mine, 3-point up front, 2-point in back.

 

Is Julianos the way to go in your opinion?

 

Julianos has most of what u need, but I have been looking at the possibility of purchasing at johnnylawmotors.com or autoloc.com not sure what I will do as yet. Any comments on those 2 webstores would be appreciated

 

This was just posted last week about Julianos.

https://www.jalopyjournal.com/forum/threads/julianos.1145535/

 

is johnnylaw under the hoffman group umbrella?

 

Went to seat belt solutions but they don't show prices anywhere.

 

Yes I believe so.

 

Seatbelt Solutions doesn't list prices but SeatBeltsPlus buys from them and their prices are low but they don't include mounting brackets or bolts with the belts. Juliano's doesn't sell belts without the brackets and they also buy their belts from Seatbelt Solutions.

 

Not technically but they are a reseller for their products. I googled The Hoffman Group and it shows all of their brands and resellers.

 

Good to know thanks.

 

I bought some belts from J C Whitney and was very satisfied with them.

 

They still around?

 

I got mine from SoCal, AZ.

 

Yep