Technical I.D. Windshield frame.

Looking for what this could have been on.

 

An Austin maybe? its mighty narrow

 

I just went and measured my Austin Ruby and it is 4" narrower than that one. Looks very similar however.

 

International Truck?

 

could be used as a sunroof

 

Yeah I was thinking international but no good dimensions on web I’ve found. Thanks goldmountain for checking your ride.

 

Has a Ford look to it, check Anglia, and other Fords built overseas. Bob

 

Bttt

 

Possible Willy’s ?

 

it does resemble International frame however too short and the hinges are wrong. This International frame is 15”
It would be a close fit for this IHC cab I chopped down 3”

 

'36 Ford (car) or mid 40's Dodge or Chevy p/u is the only other thing i can think of.

 

The frame is only 11” tall. Not much comes to mind on this side of pond. Maybe ‘30 Dodge?

 

Cuved or Flat? If curved gl*** it would be early 50's or newer.

 

I found some measurements of a '36 Ford car windshield I had taken for a friend. The width at the widest point was 42-3/8" at the widest point. The height was 13-7/8" tall in the center. Both measurements were from the inside of the window frame with the gl*** installed.

The subject windshield of this post is definitely not a '36 Ford, at least not one made in the USA. The joint between the upper & lower halves looks exactly like the Ford, but the hinges are completely different.

 

I don't know about measurements, but the shape looks like '33 Willys.