Technical It's Friday. Time for a Flathead video. Crusty Flatty Pt.11.

In this week's scintillating offering I run the vintage Buma boring bar through the non linered bores and take them to 45 thou over. I am still learning to use the machine but am getting the hang of it I think. I share my thoughts about the project and the questions going through my mind as I try to work out how to proceed.
I hope you find it interesting. If you enjoy it please reply to this thread to keep it up where it can be seen. Thanks. Mart.

 

Another great video...I'm glad they're not over. Looking forward to the next installment.

Had a thought...you could just add an extra quart of oil to fill up all the little holes and crevices...lol.

 

Hi Mart.Another great video.As my Dad used to say learn from mistakes and avoid the pit falls on your next project.Thanks again for taking the time and effort to make and post your videos.
Good luck.Have fun.Be safe.
Leo

 

Excellent video although what you are doing is way out of my abilities. I've built a few flatheads in my day but haven't done any block work other than grind valve seats and valve stems. Thanks for your post.

 

Thanks for the comments fellas.
Bumps don't hurt either. there's always a little jump in views when bumped on the hamb.
Mart.

 

Thanks for yet another interesting and educational tutorial Mart. Looking forward to whenever you post the next one!

 

"Lubrication pockets" That's a good one. lol. Enjoy your videos a lot. Keep them coming.

 

Sunday morning bump...