Technical see who has a sharp eye

Nope

 

Ahh.
There are no muffler bearings or a shore line visible in that pic, as is required is any riddle.

 

OK folks , got a winner and one really close. Yes the synchro has moved too far forward , the balls should not be visible. I fixed it by putting a hose clamp around the hub and sliding the sleeve back over the balls. Everything in trans went together nice and correct , the problem is in the shift tower, lots of wear in various place, noticed when shifting in third the shifter could be moved a smidgen more that needed allowing forks to push the sleeve a tad too far, by then they can move on like you see in pic which will result in being stuck in third.

 

Nope

 

Man I hate it when that happens.....so embarr***ing.

 

Nope , it is correct

 

Ha, you be right.

 

It is close enough for what needs to be seen, btw 600 wt is what was recommended and is what they ran when new , it is thick as hell . However , you might be right , we will see.

 

Nope, I'm still going with your shifter and top plate exploded!!!

 

I confess, it was all that 221 ci 85horsepower that did it in.