Technical Fibreglass help

Can I use paint removal on fibregl***

I have a old one piece front end for my 1956 Chevy it has old paint when you try to sand it off it plug up the sand paper

 

No it's not a good idea. Any areas that may have exposed gl*** starnds can wick it up and then it can seep back out later ruining whatever work you have done on top of it.

 

Another opinion....yes you can. I have stripped my Corvette twice with paint remover with absolutely no problems with it. I used what was called aircraft paint remover.

 

I will second Dons comment I have striped two vettes a 62 and 69 sealed them never had any problems.

 

Be sure to use epoxy primer.

 

Ok this paint I can s**** it off in. Some spots but some other spots it's hard and just gum up the paper I will try a small spot

Thanks

 

That is what I don't want to do and I'm afraid that will happen

 

I stripped my Corvette with some stuff that is no longer available, worked good but was messy and time consuming. I had removable parts, the hood, trunk, etc. media blasted...it is worth it.

 

Do you have someone in your area that does soda blasting?

 

I'm all for using vintage stuff as much as is reasonable.
Reasonable is will you ruin the vintage look you are going for and/or is it saveable for a reasonable cost VS a new front clip?
A 50 year old 'gl*** clip that was left outside in the sun and has damage will often be a ton of work and not a good finished part. Explore all options!