Anyone make a nice pre bent hard fuel line kit for a pair of Carter AFB carbs with all the fittings for the shorter (close carbs) Edelbrock intake, don't know if I can choke down a -6 line kit quite yet.
Get a tight bender from Eastwood, 5/16” line and fittings and make your own. I like using a gl*** bowl filter too. If my fuel pump was on the SBC side I would have done my Y a little different. Make all peace out of coat hangers first. Add fittings and flare first then bend. Making a few mistakes is ok.
Wouldn't the SBC early Corvette dual quad fuel lines with gl*** bowl filter work? The dual quad 409's had a similar set up. I have always used the snowflake dual quad intakes, so I might not understand that the Edelbrock intake has different spacing between the front and rear carb.
I already have the gl*** filter like the one above, didn't think about one for the small blocks, should work, I'll have to check that out.
Great, NAPA sells the gl*** bowl filters and parts still....here is how a vette came with dual quads.
The Jalopy Journal
