Customs Head gaskets???

Ok, I'm back looking for another needle in a haystack. Have a V860 with edelbrock heads. Anyway , heads were pitted so i had them shaved now I need thicker head gaskets. Have to be .070-.090. If anyone has anything laying around or a source to get them it'd be awesome. Next step is custom gaskets or having the heads machined. Both very costly. But hey nothing fun is cheap I guess. Thanks in advance.

 

You may want to list this in the WANTED section.

 

How much did you have milled off,,,,have you checked the clearance after the machine work ?
You might still be good?

Tommy

 

Why not run double gaskets? Been doing that on my 286 stroker flathead for many years.

Dave

 

Was going to mention this also. As well as checking clearances.

 

My engine guy did the clay thing and there is not enough clearance.

 

Thanks for the replies. I think I'll just have some custom gaskets made. I had thought of doubling up but my builder was against it. He's been building engines since the Bible was written so I gotta go with that. Thanks again.

 

Who's your engine builder.... looking for one.
Ed from OP NY

 

Klispie motorsports on camp rd.