Hot Rods seat location for 46 ford Coupe

Does anyone have location dimensions for a 46 long door coupe seat. All of the holes have been lost due to patch panels in the floor. I have the original bottom frame that bolts to the floor and the cushion that sets in it.

 

Do what feels good.

I have an almost stock 40 tudor that I moved the seat back a couple inches just because I could. Made for better ergonomics.

 

Place it where it suits you.

 

Have the seat in the middle point of it's travel and then put it where it feels good to you.

 

How tall are you? I replaced all the floors in my 39 Tudor, but when it came to seat mounting I made another set of holes that moved the seat back 3 inches. Made all the difference being 6 foot 2 inches tall.

 

My 39 seat has 2 sets of holes, I put everything in the wayback spots. I too will add a couple inches. To the floor! Stop giving me those looks!

There, I made the measure/dick joke 1st...

 

Found holes in the upper frame rails that matched the seat frame perfectly. The frame can be moved forward or backward 4 inches. Since I am short, 5 ft 5, I put it in the middle set of holes.

 

That makes you a wee bit taller than me. When it comes time to sell this car, I might have a problem.

 

I spend a lot of time getting the seat positioned to be comfortable for me, I also raise it up, or lower it for that perfect location. I drive my stuff for hours at a time, correct seating position is worth the effort.

 

I have a 47 long door coupe that I restored in 2014 , and as I recall the seat tracks holes go right thru the car frame and there is a filler strip between the frame and floor panel, if you measure the holes on the seat tracks, the matching holes will be in the frame.