1952-59 Ford 2 door sedan door window glass removal on a 56.

Helping a friend remove side window gl*** for replacement. Any ez hints you guys have. I’ve never done it.. thanks.

 

Try taking the regulator loose, then take the gl*** channel off of the regulator. I think thats the way I did it on the Club Coupe rear windows.

 

Been a long time since I have done this (35+ years) but as I remember on my 56 Customline I removed the vent window complete with the front gl*** run. Some screws at the top of the door then a bolt at the bottom of the gl*** run. Then there was enough room to slide the side gl*** up and out by rotating it and lifting it out the top.

 

I’m going to be doing this soon. Nosford, can you share what manual you have that the picture is from?

Thanks!

 

I have a 55 Ford car shop manual, it is a reproduction I ordered from the internet somewhere. On the back cover it says FORM 7098-55.

 

Picture of mine.

 

Thanks Dos Cincos!

 

Would this be covered in the hotrod reverends post ?

 

I went through the CD I got from him and there was parts diagrams but didn't see actual R and R instructions. Maybe I wasn't looking in the right place?

 

just saw this fellas... maybe this will help.
https://www.hotrodreverend.com/post...37-door-vent-window-***emblies-and-door-gl***

just be patient - I'm sure you will get it done.

 

danman55, once again the teacher in you comes out! Should have known! When I first saw this post my first impression was 1937 Ford vent window....... Mark