Technical Post pics of homemade bone ball mounts

Please post pictures of crossmembers and wishbone mounts for AV8 or similar. What did you use for clamps to hold the ball in? I will be using a 35 wishbone with a model A ball end welded to it and an F1 crossmember. Any pictures of that set up will be appreciated!
Thanks

 

Model A vendors sell a couple of replacement mounts, both of these are available from Snyders Antique Auto for about $25

 

Bump
I hope that you guys have some pictures and ideas
Thanks

 

Maybe you could use some trailer hitch ball parts.

 

Not sure if this is what you're looking for. This was posted on a model a site. Hope this helps.

 

Nice Thanks for taking the time

 

‘35 ford with factory front wishbone and a 9” with ‘35 radius rods using a Johnny joint in the rear. Frame modified for a T10 and open driveline.

 

This is a 35 wishbone and 32 k member. Wishbone was a little short so I used 2 plates as sandwich to match up. Used a spring loaded Model A socket from one of the vendors

John

 

I am completely stealing that ball mount idea for my 39 when I swap in the 5 speed into it.