Afternoon all, hope I am in the right section. I have on hand an Alemite 7057 strobe type spin balancer that I have no history on and would not want to damage it playing with it without first tracking down some data. The use of the item is not the issue at this time as is the wiring. It has a 110 plug on it but the data tag clearly states 230 volt. There is a relay in this compartment but no control voltage from a switch anywhere that I can find.. Motor is a brush type AC by Ametex (lamb) mode 1S14790 the first digit could be an I. The wiring field is a bit of a mess with poor wiring hygiene of the PO. Under the data tag is the electrical wiring field, there is a schematic pasted on this lid but mine has seen the worst of wear and illegible at this time. Anyone that can shed some light into this unit requirement would be a great help. A scan of you wiring schematic would be excellent. Thank everyone for taking a minute to read this and help with saving a piece of automotive service history.
Oh no.....did I Stump the Panel.....I knew this would be a long shot either way....but I also though if anyone had old literature about this item it would be this crowd.
The Jalopy Journal
