Hot Rods Is this a ‘55-‘56 Mercury engine side clutch bracket?

I have 3 clutch brackets, the one without the ball is ‘55-‘56 Ford with a Y-Block, the 2 with the balls have the same bolt pattern spacing and I’m thinking they may be for a Mercury of the same year since they used a ball on both sides of the Z-bar.
I can’t find a picture or anything online to compare these to.

 

Hopefully someone can verify. If so, there is a clamshell bearing that goes around the ball on the Mercury. Is that available anywhere?

 

Yes, the bushing is available.

 

Someone has to know if these brackets are correct for the ‘55-‘56 Mercury…

 

Here is the parts diagram from the ‘55 Mercury clutch ***embly.



The rubber washer (7539) ID is 37/64” and OD 15/16”. If the two ball stud brackets have a base measurement near 37/64”, you should be able to use one.

 

Thanks for posting that scan, I tried finding it online but had no luck. The bracket that I have with the ball looks nothing like the one in the picture, the hunt continues.