Hot Rods Edelbrock inlet washer

I lost the washer what else could use that would be resistant to gas? It has to thin.

 

I don't know,like did you call Edelbrock?

 

They don't offer them. Jegs has some but they want $17 to ship them.

 

Make your own using nitrile rubber. How big/thick is the washer? I probably have some in my project junk!

 

Check a hydraulic store, I bought thin aluminum washers that had a rubber impregnated ring on them to fit my fuel cell.

 

I'm pretty certain it's just an aluminium washer. Aluminium or copper should be fine. Or, as already suggested, a bonded washer / Dowty seal would work too. All readily available and plentiful online.

Chris

 

What about a copper washer from your local hardware store?

 

^^^^ x2 for a copper washer.

 

I'll look around for a copper washer. Thanks!

 

Napa/O'Reilly/Autozone etc usually have a good selection of copper washers, just take the fitting down with you and match it up

 

https://www.ebay.com/itm/166658340338?

select 5/8" ID, get 5 for a dollar plus two dollars postage. And wait a week.

Or look in your junk bin for a 5/8" ID washer, or gasket, or just make one with a single ply cardboard box and a pair of scissors.

 

Harley store also banjo nut washer

 

Couple drops of blue lock tite no washer needed , just a thought

 

You might look at Auto Zone. Here they have Edlebrock inlet hose barb fittings and tube flare fittings with the washer.

 

Found copper washers big enough, no leaks.

 

Where did you get them?

 

O'Reilly I had to hog them out a little bit.

 

Thks