Projects Rehpotsirhcj’s 30 Flathead Coupe

It looks like the 8ba has possibilities. New rings for that bore are difficult to find ( my experience), but the decks have been cut as there is no sign of corrosion in the picture. I suggest checking the bores for rust damage and clean the sludge from everything. If you have a fiber timing gear, replace it.

 

Gotta love electrolysis.
Here drums off the same rear, wire wheeled and Evaporate-rust soak on the right, 10hr 6 amp electo on the left:

 

Project for this Fall:

 

Great, who's is that one?

 

It’s my first QC, and so will be a learning experience. Winters SR3620 Center section that @krylon32 set me up with on my minimal budget. I have to decide what year bells I want to go with yet. I felt a QC was a must-have and I’m looking forward to learning about them as I piece this together.

 

The 57 has been taking all the time and money recently. Not to mention the new seat upholstery for the 53 and a Fenton split exhaust found at the swap meet. But, I now have 100 amp to the shop (pending inspection) and so hopefully very soon a real welder, good psi etc. so that I can turn my attention back to the coupe ch***is. In the meantime a little surface rust removal. I need to strip the tulip panel too. So if anyone has suggestions on a stripper that works well and that won’t kill me let me know.

 

"So if anyone has suggestions on a stripper that works well and that won’t kill me let me know."
can't have it both ways....

 

Chris, I've used these type discs before, a good particle mask and eye protection is advised,: 6 Packs 4-1/2" x 7/8" Strip Discs Stripping Wheel Fit Angle Grinder Clean and Remove Paint Coating Rust Welds Oxidation - Amazon.com

This is just one example, 3M makes a very good version that should be available locally at a paint supply store. They come in bigger sizes as well if that's preferred. I did a body like yours a few years ago with four discs and a few hours time.

 

Hi Bob! Long time.
Great suggestion. I think I have a couple of those from HF somewhere. I’ll give them a shot.

 

Yup, the little stripper disks work well. One disk stripped the full panel. Found a couple of small dings and a little pitting, but it’s an honest panel overall.

 

There's a lot to unpack in that question

 

lol there is at that!

 

Welp…here we go.

 

Great build. Keep the updates coming.

 

This came today. Cheapest repop on eBay, but looks the part until the day I can lay down cash for a real one.

 

Not much of and update. Things have been busy, and the shop pretty cold. I did buy some petals listed as 39. I don’t think they are. Oh well. I’ll see I can make them work when the time comes.

 

Back to the quickchange.
I borrowed @brsturges ‘ Banjo Bell Build Base trick. I can see how this could make things easier. I made them stout enough to trip over later.