Technical Early Hemi #2 (354 Hemi build thread)

George, Yes! This will absolutely be part of the process.

 

Deck the halls….sort of….


Can easily see the first p*** the deck is not square. Compared to the last rough cut.

taking 0.040”. I think I should end up somewhere around 9.75:1 without actually measuring.

 

Forgot to take after pictures but the block is done, tomorrow is I’ll be clean, clean and clean some more than cam bearings and ***embly can begin

 

Take a piece of uncoated welding rod and drop it down the head oiling holes to verify the cam bearing are in right.