Technical Well I went and did it !

Same gear ratios ?

 

The 319 OD pops up sometimes fairly reasonable around here. Non-sync 1st
I’ve got a Saginaw OD I’m saving for a future project.
A 319 would be a direct bolt in
I’ve got one from a tri5 the owner didn’t use the governor and worked the solenoid with a switch on the shifter

the OD is .70 I think. Could use a low rear gear with that

 

Cool stuff
A six with some goodies and a three on the floor sounds fun.
I had an OT 4wd with an in-line six (stock) and a three on the floor 3.50ish gear I think probably 500-1000 lbs more than your 56. Loved it, not a hot rod but it did ok, never cruised over 65 much but I did drive it all over the western US. I’m sure your engine will make more than the 110 hp I had.
Dan

 

The old ‘56 3 spd/OD works like the later all synchro trans when the OD is enabled. But if you have the later trans available cheap I would try that. Especially if you can get your hands on an OD version.

 

Can use the current shifter on a 3 speed OD
After some slight mods

 

A factory over drive would be cool as cool can be .

im planning on daily driving this thing so hwy speeds are important

I don’t need dragster launches , but a nice hwy cruising speed is essential

@anthony myrick would you be willing to part with that od ? Shipping will probably be a biznich

 

The 2 nova trans are free and I get everything flywheel clutch kits bell housings trans etc the whole schermozzle X2

 

The ‘55-‘57 style 3 spd/OD trans is fine for what you say you want to do. They just seem to have fragile gears, especially when speed shifted by sloppy column shift linkage. Be nice to it and it’ll last forever.

 

Free is good…..

 

I like free.
The only thing better than cheap

 

Why does a free beer taste better than buying cheap beer?

 

​

 

All I can say is "you gotta raise the bar", three speeds, Saginaw four speeds

 

I like 3 speeds

 

The 1956 will need a bell housing with side mounts, to work with front crossmember engine mounts.

Or convert to side engine mounts and a rear trans crossmember.

 

His buggy is already set up with factory bell.

 

Not real sure how you mean that.
But don't forget the size of the torque curve in a six pack.

 

Man inline 6 speed stuff is so damn ***y !!!

 

Now you're gettin' it. Go for it!

 

Pleasantly surprised
Pulled the vc and side cover off this morning looks pretty good inside

gonna tear it apart , at the very least all new gaskets and lap the valves .

Will keep you posted