Technical Where to get a SW tach drive cable made?

I was fortunate to find a Stewart Warner pulley mounted tach drive. I don't have the cable for it. It would need to be two, keyed male ends. Looking for recommendations on how can make this cable for me? I would also like to use an old armored cable housing/sheath that I have, but it's too long. Can a speedo shop shorten these?

Thanks,

 

Get a hold of @e1956v on here, if they cannot do it I would be surprised. Their website is www.speedoservice.com

 

Thank you! Will do.

 

Pretty sure Rusty can help you out. HRP

 

Great. Need to install it first so I can get an accurate length of the cable. Once I do, I'll give him a call.

 

try Bob's Speedometer, in Detroit
https://www.bobsspeedometer.com/

 

How long do you need it to be? Tractors use mechanical tachs and the cables are fairly inexpensive.

 

C1 corvettes use cable tachs. check ecklers corvette on line

 

Dorman Help 03368 Universal Speedometer Cable Kit 72" w/ Tip. if this won't work look on ebay lots of premade cables. you may stop by an old simi truck parts place before the early 90's every truck had a cable drive speedo and tach.used to use this cable tool a lot but not much anymore

 

Another vote for Rusty in Colorado.

 

Thanks, all. I'll call Rusty once I get the drive installed and know exactly the length I need. I'm also hoping he can shorten the armored shield too.

 

@e1956v , are you able to help?

 

Not a problem at all.
Can make up a new one complete or shorten the existing one.

 

Great. Thank you. Once I have it and installed, I'll be in touch to finish up with you to make the cable.