Floor board prep

Hey guys,
Its been awhile since I posted. I just finished this past semester at school and I am on winter break so its time to get back to the projects. I have a 55 4 door bel air that have pretty good floorboards. There is some surface rust on them and was wondering what would be the best approach to cleaning them up before I install the carpet. Should I do the Por-15? Or should I sand them down and paint them? Any and all suggestions would be greatly appreciated. This may be a "newbie" question so please excuse my inexperience.
-Cory

 

I'd go POR15, had great luck with it on floors, just follow the instructions. Read the other thread by Abomination about frame/underbody going on now too.

Bill

 

Ok, if I go with Por 15, where is the cheapest place to buy it? Do they sell it locally?

 

You should be able to get it at a local autobody supply store. If not I always get mine from www.por15.com but these guys are closer to you http://www.por-outlet.com/

 

Went to website and purchased special number 3. Thanks guys
-Cory