(Oh Boy...here it comes!) I'm NOT kidding, though!

[ QUOTE ]
Maybe you can figure out a way to dump the six and fit a Te***sah engine...


[/ QUOTE ]

or a BRIGGS & STRATTON!!!!!!!!!!!!!!!!!!!!!! this is the culmination of my being......................................................Briggs

 

[ QUOTE ]

and as far as shriners go, man, i'm not a shriner, i'm pretty sure that there is a rule against that in the masons, somehow...

[/ QUOTE ]

ChromedRAT- There's only a few degrees difference between a mason and a shriner.

 

That's the perfect car , if ya happen to be Wee Man from Jack*** or one of Santa's evles, one look from the side tells Me that leg room would be a problem, now if a guy could remove the diamond plate and set the seat further back, well atleast then ya would'nt be hitting Your ears with Your ankles while sitting in it. I do think it has possibilitys. Von Doc

 

Shipping would be easy - just stick it on Greyhound in the compartment under the bus

It is small enough to put in a box van on a couple of pallets and ship it Roadway or Yellow etc. - maybe not

 

Didn't really check the Ebay pictures, but I don't think removing the diamond plate is going to add much room. I think it's just there too cover up the rear end , spring, and whatever is there for a frame. If your really that bored and need a project I'll send you my 53 Chevy up to you to have the quarters replaced.

 

Ya know..
I got enough extra **** around, including the body pieces ta put one of them Rodeo cars together too.
I think I will!
and I bet when I cruise Rodeo Drive in it it'll knock them Beverly Hills clown's size 22 Bruno Maglis right off their feet!