Register now to get rid of these ads!

Gearing/tire size......???

Discussion in 'The Hokey Ass Message Board' started by choprods, Apr 12, 2004.

  1. I got a question- with the 14" tires -I believe they are 205-70's that I have on the '58 El C it seems so incredibly low geared at 70.I believe I have a 3:70 gear now......
    how much improvement can I expect from say a 235-75 15 on the rear instead?I would say its about 2-3 "taller a tire than whats there.
    Ive been thinking of a set of chrome reverse/baby moons to replace the ol 5spoke MAGS as they are cheap and are available in the offset I need.will this be enough to make a difference or not?
     
  2. Am I crazy or did Chevy never make a 58 El Camino??? Bad *** ride!!!..and I like the 5 spokes on there!!
     
  3. It ****s that lagitimate questions like these fall off the front page... but here goes.

    According to my Mark William's Gear Ratio "computer"... each inch that you gain in tire diamter, you will lose a tad more than 100rpm at 70mph.

    It shows that a 25" tall tire, with a 3.70 gear at 70mph will make your motor turn a tic over 3500rpm.

    With a 28" tall tire your rpm's drop to about 3150 at 70mph.

    FWIW, the effects of changing to a 3.56 gear are as follows:

    25" tall tire, 3.56 gear, 70mph = 3390rpm.

    28" tall tire, 3.56 gear, 70mph = 3000rpm

    Now the hot ticket for hwy cruising is a set of 3.08's

    25" tall tire, 3.08, 70mph = 2900+ rpm

    28" tall tire, 3.08, 70mph = 2600rpm'

    Or better yet, swap in a 700r4 trans and keep your low gears and go with a moderate sized tire...

    Sam.
     
  4. thanks Sam-an guys- I am into my ANTI TECHNOLOGY phase- no ODrives to **** me over and quit......Ill try the tire swap first then maybe the 3/08 gear set-this ***** really howls!speedo is at least ten MPH fast
     
  5. CruZer
    Joined: Jan 24, 2003
    Posts: 1,934

    CruZer
    Member

  6. Yeah Marcus-you are not nuts.......its a phake
     
  7. Sam's right
    Drop in a 3.00 to a 3.26:1 gear and then say a 26-28 inch tall tire.
    Good all around gear.
    I have a javascript here attached to an article on gearing. I never could figure oput how to post it so it never made tech week.
    I think I could e-mail you the article or put it on a floppy for ya. Then you can compare gearing and tires to your hearts content.
     
  8. Deyomatic
    Joined: Apr 17, 2002
    Posts: 3,316

    Deyomatic
    Member
    from CT

    I thought the Bel Camino was sold a few months back? Wasn't it on ebay? I'm glad you still have it, that was one of my favorite vehicles at the HAMB drags.

    I always play around with the Richmond one that is posted above. VERY helpful.

     
  9. Joe Bardell
    Joined: Nov 26, 2003
    Posts: 43

    Joe Bardell
    Member

    FWIW, in case ya didn't know:

    195/65/R15

    195 millimeters wide
    65% of the width of the tread is the height of the sidewall
    Radial for 15" rim

    That might help with picking out tires in these damned metric sizes. I hope my info was right
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.