Hi, I've got an engineer friend make up some radius rods for me ( 1" solid rod, threaded ends, 2 tubes 5" apart at axle running down to one tube where it meets the frame ). Where I live it is hard to get the bushed rod ends or clevis fork type ends, but I can get some high quality heim joints. Are these OK in this application, I was thinking of putting washers either side of them to stop the joint popping out. Theres been a few threads on this before, they will be 5/8" thread and hole. Thanks, Craig.
i would like to know too i have other options but this would be easier as i can get heim joints with grease ******s they are 5/8 or bigger and used for tractors 3 point hitches so i know they are strong
Just be sure to use the heavy washers larger than the outside end opening which enclose the central bearing ball and you'll be fine.
I see your in Auckland, go and see Lance at Freelance Automotive as there may be Certification issues with using washers to hold suspension parts together. He'll put you straight.
The Jalopy Journal
