Series 2 10 bolt Camaro Torsen Carrier

Hi All,
we're on the hunt for a new diff for our lakester
http://www.jalopyjournal.com/forum/...04&highlight=bellytank+in+australia&showall=1

after speaking to one of our good friends with his feet on the ground here in the good Ol USA we are trying to locate a 10bolt series II 7 and a half inch Camaro rear end so we can run ratios down to 2.14.

We have friends going to Bonneville this year and the aim would be to muster parts and then get them brought back with one of the cars that are going to Speedweek.

Thanks
Dr G
In Aus.

 

Still looking

Thanks.

 

BTTT

someone out there can help an Aussie out

later jim

 

7.5" Camaro rear...Is that 3rd generation?
The Regals and S-10's had 7.5 or 7 5/8" rears.

 

If the Torsen diff is now the Detroit Truetrac, the part # should be 911A319.
Hope this helps. Good luck guys!

 

not sure what generation they are but have been told they have the following ratios... 2.14 2.28 2.53 2.73 2.9? 3.08 , and that they are 28spline axles....my source said they are from a Camaro...

thanks for the help so far everyone

<input id="gwProxy" type="hidden"><!--Session data--><input onclick="jsCall();" id="jsProxy" type="hidden">

 

Hi, still lookin for one of these, we ran 193mph in the mile this year , doing some motor mods so she'll rev harder and want to lift the final drive a little.

here's the story of this years run.....

http://www.jalopyjournal.com/forum/showthread.php?t=211504&highlight=bellytank+in&page=7