junking a car in Kansas city.......

I never had this much trouble in NYC, LOL
how do i s**** this rotted piece of junk 55 caddy i cut up with no ***le.
I'm cheep and want to get its weight in s**** cash if i can.
any ideas from you local guys out there?
FRITZ

 

should be able to trailer it to the local s**** place, they'll weigh you in and out and pay you the difference!

 

Fritz i think you have a problem .i know that in kansas city kansas you need a ***le . My best advice is made small parts . But thats lots of work . Good luck . Dale

 

leave it at one of those casinoes and drive off..seriously,look into kansas law and try there.

 

you can take it to galvmet metal recycling
north of I 70 and manchester. just haul it up on a trailer and they will
pick it off . no gas tanks intacked

 

The guy across the street has done a few, but he had so much trouble he wouldn't do it without a ***le after that.

I just don't know, man... but hell, I'll do a bump for your thread though!

I'll bet a local body shop or the KC Auto Auction might know...

~Jason

 

****, yes! I'd totally forgotten about them!!!!

They're a few miles from Langley.

~Jason

 

if you have much more than a frame and some rusty sheetmetal you didn't part it out good enough.

I've parted 3 cars here in sunny California... when I was done I cut them up into pieces that could be loaded by hand and the local s**** guys came and got them.

 

id just cut it up and take it to a s**** yard, if they ask say the tile was in the glove box, and you dont know what pile that is in

 

Advertize it as a parts car, try to sell the carcus..

 

Cut it up, then tell them it was a toaster...a very large toaster.

 

Last couple I did with out ***le, they said no problem as long as it didn't have a motor. Then I went back a couple weeks later with a load of motors............

 

You take it over to the schredder in KCK. No ***le necessary in KS.

 

Now THAT sparked a memory!

Those were the dude across the street's exact words!

~Jason