Need small 9 inch drums, where?

My 69 bronco rear has the 10 inch drums which measure about 10.5 inches, and my wire wheels are about 10.5 where it meets the drum. Will not go on. I know there are adapters but that puts me out another 1.25 inches on each side. Is there a smaller drum/backing plate out there that will bolt up and let my wires fit over the drum??

 

Just realized another problem, my stock bronco brakes are 2.5 wide and the only 9 inch brakes I'm finding are 1.75 wide. Anybody know of anything?

 

28-36 Ford wire wheels are supposed to contact the drum at the outside flange of the center and the hub at the wheel studs.

 

Yeah I know. Putting the spacers on and wires puts me at 60 inches center of rear tires and that is going to put my tires out to far for a fendered car I think. The bronco rear is 58 flange to flange which is great, but because the way wires are designed, I have to run a spacer which technically makes it 60. Is this two wide for a fendered car??

 

I believe that the mid 90s ford rangers had 9x 2.5 rear drum brakes.

 

I would use the spacers and work on a shorter rearend. them wheels need to lay on the drum face and using a smaller drum is asking for trouble.As for your rearend if it is 58 inch outside and 60 with the spacers and it is 2 inch to wide you need a rearend that is 56 inch wide with spacers which will give you 58 inch. 56 inchs is a common size for ford. If your worried about the smaller bolt patterent the spacers will fix that.