Register now to get rid of these ads!

Rochester 4gc flooding

Discussion in 'The Hokey Ass Message Board' started by 396belair, Oct 20, 2009.

  1. 396belair
    Joined: Nov 28, 2008
    Posts: 14

    396belair
    Member

    My '63 Impala has a 327 with a stock 4GC on it. It runs fine, but when i shut the car off, fuel pours down the inside of the carb and floods the engine out. Any ideas what might be causing this?
     
  2. hubcap
    Joined: Feb 24, 2007
    Posts: 198

    hubcap
    Member
    from phx

    How hot is it? Can you touch it with your bare hand?
     
  3. yorgatron
    Joined: Jan 25, 2002
    Posts: 4,228

    yorgatron
    Member Emeritus

    crud in the needle/seat,or the floats got holes in'em and are sinking.
     
  4. JohnEvans
    Joined: Apr 13, 2008
    Posts: 4,883

    JohnEvans
    Member
    from Phoenix AZ

    Front or back or both sides? Check fuel pressure and if only one side the needle/seat. As hubcap said how hot is the carb getting? If the heat riser on the exhaust manifold is stuck shut or close to it a lot of the exhaust gases will be going under the carb base making it get to hot and boiling the fuel when you shut off.
     
  5. 396belair
    Joined: Nov 28, 2008
    Posts: 14

    396belair
    Member

    it looks to me like its coming from both ends. the heat riser is tied wide open, and the carb doesnt seem like its excessively hot. as far as the needle and seats go, the carb was remanufactured when i bought it, and ive had it apart at least 10 times now, so there cant be anything affecting them. headaches...
     
  6. Arthur1958
    Joined: Jun 29, 2009
    Posts: 232

    Arthur1958
    Member

    Sounds like a stuck float. I think 4GC carbs have three.
     
  7. panic
    Joined: Jan 3, 2004
    Posts: 1,450

    panic

    1. float too high (probably not, if it runs OK)
    2. needle & seat leaking
    3. fuel pressure too high
    4. vapor lock (but that will stop after a few seconds)
     
  8. shemp
    Joined: Dec 16, 2006
    Posts: 512

    shemp
    Alliance Vendor

    4GC's have soldered together br*** floats. Make sure they're not leaking. #1 guess is ****ola in the needle and seat.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.