engine leveling

I know u throw a level on a 4bbl intake to set up ur engine. My question is I set my engine up with a 4bbl manifold with the degree built in to it so carb is level and engine bout 3 degrees down.

But when I put on my edelbrock X1 6x2 the intake and carbs arent level on that intake. They are going down with the engine angle

This normal or going to be a problem?

Thanks

 

I dont think it should cause a problem .Im just thinking about boat carbs ,there not ever level 3 degrees I don't think will cause you a problem.......

 

you gotta jack up the back end of the car enough to get the carbs level

 

when you go up or down a hill it'll all work out

 

the blower on my car makes the carbs sit at an angle too...never had any problems with it that I could blame on that.

 

make sure your driveline angles are good.

 

make a carb spacer that will take the angle away. just for looks

 

Thanks for the help, Even though i dont like it I can deal with the look. I just wasnt sure if a few degrees would be enough to worry about floats etc on the strombergs

 

Adjust your floats and you'll be good...