finally changed my tailshaft

After a lot of looking finally found another world cl*** transmission. Got it tore apart and it all looks good. Pressed the gears off and got ready to change it over to my gears and got to looking after i got the gears on it, i have lost the little ball bearing out of where the speedometer tone ring goes on. I looked all over the garage floor but still not luck. So now all i have to do is come up with that ball bearing or one to replace it and put the tailshaft on. I will be ready to go. After that i am gonna put the trans behind the engine and put it in the frame to stay. All held up by a little ball. Anybody know where to find one of those?? or what size it is. It is wc with elec. speedo

 

Ace Hardware etc. should have a selection of loose balls. Use a drill bit to get a idea of the hole size for the ball,close is good as long as it goes in the hole and stick above the surface a bit.

 

got it all back together and put it behind the engine sittin in the frame. gonna start test fitting all the parts now.