Register now to get rid of these ads!

BenD needs help in Arizona.

Discussion in 'The Hokey Ass Message Board' started by JimC, Nov 27, 2004.

  1. JimC
    Joined: Dec 13, 2002
    Posts: 2,243

    JimC
    Member
    from W.C.,Mo.

    BenD is having tire woes on the trailer.
    He lost tread on one of the tires, put on the spare, now it is flat.
    He is near Casa Grande(sp) Az where I 8 and I 10 split.Is there any one near that can give heim some help or at least sit with the trailer and load while he goes for tire repair?
     
  2. Assdragger
    Joined: Jan 28, 2002
    Posts: 819

    Assdragger
    Member

    Ben would help anyone on this board (and has), I would give him a hand if I could!

    Besides, If we dont get him on the road....he`ll be late to pick-up my Road Runner!! [​IMG]
     
  3. JimC
    Joined: Dec 13, 2002
    Posts: 2,243

    JimC
    Member
    from W.C.,Mo.

    If some one in the Casa Grande or Tuscon area could go sit with the trailer and the load while he drops and goes for tires, would help.
     
  4. ELpolacko
    Joined: Jun 10, 2001
    Posts: 4,682

    ELpolacko
    Member

    DO you have a phone number for him??


    Give him mine, 602-278-6800 or my cell number 602-885-1522
     
  5. FLAT-TOP BOB
    Joined: Aug 19, 2002
    Posts: 1,968

    FLAT-TOP BOB
    HAMB O'dex Editor

    bens number is 417-818-0844
     
  6. I've had that happen, can he try to put the good tire on the rear of the bad side and leave off the front one?
    It should float above the ground. I made it over 100 miles with a car on the back that way. I didnt fix it cause I didnt have enough $$.
    He might be able to get to civilization that way.
     
  7. Maybe over simplified but, what Bolt circle on the trailer?.....what bolt circle on the vehicle on the trailer?

    Just a thought.
     
  8. JimC
    Joined: Dec 13, 2002
    Posts: 2,243

    JimC
    Member
    from W.C.,Mo.

    Elpoloko is going to contact Ben.
    He may even have a tire and wheel that might get Ben to where he can replace tires.
     
  9. JimC
    Joined: Dec 13, 2002
    Posts: 2,243

    JimC
    Member
    from W.C.,Mo.

    GM truck 5 on 5
     
  10. Three cheers for ElPolocko.
     
  11. ELpolacko
    Joined: Jun 10, 2001
    Posts: 4,682

    ELpolacko
    Member

    Just got off the phone with him, sounds like its under control.

    That section of road has consumed lots of trailer tires for me. I lost two right side radials headed to Tucson a few years back and this years trip to MOKAN chewed up a right side, different trailer.

    I switched to heavy truck Bias ply tires on my trailer a while back and it solved all sorts of driveability issues and picked up a few points in mileage too. Never again will I run radials on my trailer.
     
  12. Munson
    Joined: Dec 27, 2003
    Posts: 198

    Munson
    Member
    from Tempe, AZ

    Im alot closer than ElP to where Ben is at. If he needs something tonight tell him to call me
    (I may be drunk though) **X **X ****
    I can't see him having any issues at the intersection hes at. Its without a doubt the busiest "big rig" interchange we have in AZ. All the, truck stops, washes, stores, ******s, a gear jammer would need.
    I really don't know about the ladies but you know what I mean [​IMG]
     
  13. JimC
    Joined: Dec 13, 2002
    Posts: 2,243

    JimC
    Member
    from W.C.,Mo.

    BenD Is on the road agein with all four tires holding air.
    Hopes to make LA this evening.
     
  14. Hope he pushes it tonight. Any road coming into SO Cal is gonna be Fooked from holiday traffic tomorrow.. And its gonna be raining tonight. Cajon P*** (I-15) will most likeley be snowed in or closed. Same with the I5 through the g****vine..
    Good luck to him!
     
  15. ELpolacko
    Joined: Jun 10, 2001
    Posts: 4,682

    ELpolacko
    Member

    BenD just left here 20 minutes ago. I gave him an extra spare tire just in case.
     
  16. palepainter
    Joined: Sep 28, 2004
    Posts: 366

    palepainter
    Member

    Just talked to ben. He is rolling.. In good spirits. I have an employee in Casa Grande too. Bummer I just caught the thread.

    Keep on truckin Ben,
    Mike
     
  17. MilesM
    Joined: May 28, 2002
    Posts: 1,220

    MilesM
    Member

    Hope all is well. Glad to here he is on the road.

    BenD, I am in Long Beach for the swap in the morning. Heading back via San Diego mid day. Call my cell if there is anything I can do. Thanks for hauling the seats out. It was good to meet you. Stop in AZ when you can stay a little longer! Kerry will grab that grille and surround from Root after you get through there. Thanks again

    Palepainter, good to meet you also. Cool project, keep us posted. See you around.
     
  18. palepainter
    Joined: Sep 28, 2004
    Posts: 366

    palepainter
    Member

    Like wise Miles.
    The saws and welder will be flying shortly.
    Stop by the shop any time. Bring that roadster of yours by for inspiration.

    Mike.
     
  19. OPMC
    Joined: Dec 4, 2004
    Posts: 13

    OPMC
    BANNED
    from badlands

    For some of us getting to the northern end of the 101 loop is just not possable. We are not looking to step on any club feet. We are looking for a southern phoenix area to meet. We are looking for people in the phoenix area that are looking for a weekly place to meet and get to know each other, trade parts, get information, and more. We take all kinds that just want to show off there custom cars and trucks. All are welcome. If you are looking for a place to learn, teach, sale, buy or show off, please let us know!!
    below is a link to a quick servey that will help us structure the club to best serve our members. Please, Please take a few seconds and help us bring a wonderful group together!! THANKS

    http://www.misterpoll.com/3876871545.html

    If you have questions or would like to know about membership (free) please Email us at Olpartsmine@yahoo.com

     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.