Nailhead questions

I know not much interchanges between the different nailheads. I have a 364. Was woundering if some day I pull the motor, will a 322 bolt into the same motor mounts? Also is there anyone who makes 3x2 intakes for the 364?
Thanks

 

Offy makes an intake, still does. Dmarv probably has one.

 

elco make one

 

Not for a 364 they don't. And then go ahead and do a search here for Eelco and/or Northwest Speed then decide wether you would give them your money.

 

ok, how bout the motor mounts? If I mock up for a 364, will a 322 bolt in?

 

I had a 322 but I don't know as much about the others. I have some interchanges list around here somewhere. Just email me or send a PM to remind me. Also, Brad54 knows tons on these things. Look him up.

Chris

 

Good article I was reading last night:

http://www.webrodder.com/article.php?AID=58&SID=4&CID=

Lots in common between the 364-401-425, although there are some important differences. I think the motor mounts will match.

I've got an Eelco lifter valley cover, it's a nice piece, but I didn't buy it from Eelco.

 

i have a set of mounts here from a 364 & a 401, i can attest that at least the bolt holes to the block line up. I sure hope they're the same otherwise I'll not get the 401 into my '57!