What parts need to be manufactured?

I need wind wing frames to fit a chopped 48 dodge town sedan.. 2 front and 2 rear .. stainless would be great,, steel will work... i can make up patterns for door and gl***.. i have been looking for quite a while on dodge sites ,, no luck.. kind of at a standstill... no use going any further without ....

 

These '53-'54 Stude grille bars and surrounds are being repop'd in cast br*** and go for about $300 each. Maybe they could be machined out of aluminum, sold polished or paint-grade. Also, any Hawk trim.

 

1941 plymouth grill and trim in stainless...with custom changes (need the two long front trim lines longer than the original)....

 

3x2 cadillac intakes!

 

a good set of hood hinges for 52-54 ford cars,make them stronger and adjustable..

 

A nice aluminum 4bbl intake manifold for the nailheads and for under $10.

 

Headlight bezels for 53 chevs

 

I'd like to see a re-pop of the low profile three deuce air cleaners J C Whitney had in the early sixties. They were oval on two sides and flat on the other two sides so that they fit close to each other when lined up together on the carbs. I used to run them on my hopped up 348 '60 Chevy back in the day. GTOs with factory 3 deuces had similar but taller ones but because the center carb was taller than the ends they just didn't look as cool.

 

I'd like to see the curved roof pieces above the door for 29 A coupes.

 

Affordable pre-drilled door hinges for model A's and similar cars made of steel.

 

www.modelahinges.com we are an alliance vendor also 10% off..