Shop truck on all 4 stude inside

first time i got it on all 4 with the air ride in still need to wire and run fuel and air lines

 

I love the look of your truck! Keep it up, it is going to be killer!

SpeedAddict001

 

Nice!!! Love the Stude lines

 

Man, that Stude is way low! Is it just me, or does the rear axle look like it sits about 5" or 6" too far forward?


Later, Kinky6

 

That happens a lot in an airbagged truck with a 4-link when the airbags are deflated.

 

i stil have to cut the front of the bed to center the rear wheels it was a long bed to start with

 

Ssssssswwwwwwwwweeeeeeeeeeeeeetttttttttt!!!!!!!!

 

the rear wheel wells are strange on these trucks ive been trying to find what looks like center for wheels for a while jus have to make the cut and live with it

 

Well, the rear fender opening looks wider than the opening on my truck. That maybe the reason why it may not appear centered.

I want mine sitting that low, so I gotta know, what chassis setup are you using?

 

camaro clip tube back with four link

 

Wish mine was that low!!!!

 

whip out the torch

 

this shows the wheel well offset

 

Oh, well that is half way what I have. I have the camaro clip, just need the 4 link and that was the way I was going anyway.
If the last picture you post the truck you used, then that would make sense about the fenders being wider, its a 1 ton?.
That is still sweet though. Also did you use a 4 link kit or just made one?

 

i just made one

 

hmmm, might be intersted in making another for me, lol.

 

Love the look of that truck. If it were mine I would shorten the opening of the rear fenders but sectioning the fender and then cut the excess off the back of the bed to make it a short bed. Really nice truck!!!

 

i dont want to have burn marks on the paint because goin to leave it as is

 

love this truck. cant beat the look of a dunked stude