A Arm funnycar suspension

My question deals with the front A arm suspension of a funnycar ch***is. What is the size of tubing used in the fabrication of A arms front suspension in a funnycar ch***is?

 

I'll check on our car. it might take me a day or so, the shop is 20 miles from me.

 

mark williams &other company's have kits for sale giving specs&jigs for setup
nhra hand book?

 

best route to your answer is SFI...

http://www.sfifoundation.com/

 

ask Rooman....he might have an idea since he builds TF cars

 

Or you could run aluminum A-arms.

 

Thanks for the response ,my ch***is is 85% done but still needs the front suspension and rear 3rd menber to be fabercated .I was useing a straight axle but trying to the a-arm set up thanks

 

photo

 

Actually SFI could care less about what holds the car off the ground. All that the SFI specs cover is the construction of the part of the ch***is that surrounds the driver (and a few other sections in the case of Top Fuel).
Most floppers that I have had anything to do with use 1.125" or 1.25" for the upper leg and .875" for the lower (double) section.

Roo

 

thanks for your help Roo