32 bones..perch pin fit..??????

Was mocking up my front end today and noticed that the bottom of my 32 bone have the tapered hole...wondering if I can buy the tapered washers or should I make my own...it's a pain because I'm lacking the equiptment to make any..ideas...my buddy tells me to go ahead and tighten it as is..

 

What sort of shocks are you running? The mounts for tube shocks are tapered to fit into the bottom of the wish bones.

If you're funning lever shocks you'll need a spacer, or an original style perch nut that has a taper on the backside of the nut.

 

i sell 'em at so-cal. give me a call and i'll mail you a set out. or, you can order them on our website. (916) 924-9744 or socalsac.com i'll be in tomorrow from 9:00-5:00.

 

No shocks there..suicude front

 

Sounds like a deal..thanks..I might of lost them.....not even sure if I got any!!!..parts have been laying around for 6 months..

 

you can buy them. they are called front spring perch nuts. there tapered

 

Ok, then you'll need these:



http://www.thehotrodcompany.com/shopnow/show_item.asp?product_id=A6121

The Hot Rod Company carries them, and they're an alliance vendor!

They also have a nylon, lock nut style too. Personally I like the look of the castle nut with a cotter pin.



http://www.thehotrodcompany.com/shopnow/show_item.asp?product_id=2666S

P.S. They also stock some of the best Hot Rod films known to man!

 

I drilled out regular wheel nuts Dont remember how I found the right size

 

Zombie..just bought the cotter type nuts..thanks..nice stuff at the Hot Rod Shop!!..I'll be checking it out as my build develops..