Here it is - another year of auto shop class for Seattle Lutheran High School with the '58 Ford Ranch Wagon. Thanks to everyone who followed along and provided encouragement for last year's class. Year 1 of the build can be seen here. About the class: This is an all-volunteer funded and taught class for Seattle Lutheran High School in West Seattle Washington. I'm Dan - the class was my idea and is taught in my garage - but it wouldn't be possible without the help and support of others. Namely my helpers Dave and Ken (Ken is new to the project this year) and my wife Karin who puts up with the late night garage sessions, all the missing Sunday afternoons, and all the unforeseen expenses. The class meets every other Sunday afternoon from 1-4pm, for a total of 19 class sessions over the course of the school year and for this effort the students will earn an elective credit. I will post a summary of our accomplishments (however small they may be) after each class. This year I’m going to ask the students to contribute to the class summaries. I limit the class to four students and as of right now we have three signed up for this year. We had a great group of guys last year and I'm looking forward to another fun group this year. The car: If you followed along last year you know that the car underwent quite a transformation. I was hoping to sell the car over the summer to fund another project that would be an equally big transformation. No one bought the car, so we did a little work last night to help ensure that it would look like a big enough project when class starts tomorrow. Once again, the goal is to get the car on the road for the Billetproof show in Chehalis in June. Here's what we started with last night: At the end of the night we were ready for the class to start:
We had our first class on Sunday, September 12th. After a brief introduction and safety orientation we jumped right in and started removing the motor. One of the students dropped the class before the first session, so we only had two students for the first session - Jake and Kelli (different Jake from last year) - but another student has registered so we should be back up to three by the next class. Our goals for the first couple months are: - Remove the engine/trans - Replace rear main seal and fix other minor leaks on the engine - Remove all front suspension - Clean and paint frame - Rebuild all front suspension - Clean and paint firewall - Rebuild the carb - Clean/fix/replace/paint all front sheet metal - Put the front end back together Here's Dave and Kelli working on disconnecting the motor: Jake and Ken work on taking the motor apart
Since the first class session our no-show dropped the class and Kelli transfered to a different school. But we added Mitchell, Zach, and Anika - so we're back up to a full class. This week Anika and Zach worked on taking the front suspension apart while Jake and Mitchell worked on replacing the rear main seal. The front suspension came apart without too much struggle, but we confirmed that we need a new driver side lower control arm. Now we're down to a bare frame that the students can clean Here's Ken teaching the students about a motor's innards Now the hunt is on for a new lower control arm. I just talked to a guy today who's parting out a '58 4 door, so I'm hoping to pick up some parts this weekend. <!-- / message --><!-- sig -->
That's a great project. Just as well you didn't sell it. 57, 58 & 59 are probably the same for most parts suspension wise.
Anika was out sick this week, so it was just the three guys. I had put together a checklist of things to do to the motor and the front end and they did a good job of working their way down the list. On the motor they were working on cleaning it up, touching up the paint, putting the oil pan back on, replacing the fuel pump, etc. On the front end, the focus was on cleaning. Each student spent a half hour or so at the sand blast cabinet cleaning suspension parts and we also started grinding the frame to prepare for paint. Here's what I love to see - all the students hard at work I had cleaned up one of the A arms and painted it, so Jake put some of the new components on it.
The Jalopy Journal
