I have three Grant/Spalding Flamethrower distributors. Spalding #4347, Grant #004197, and Grant #05005. All have straight blade type shafts that are different lengths so I'm thinking Mopar but I'm not certain. Anybody have part or casting number info for these units? Thanks for any help!
Need some pictures and the actual lengths. The Chryslers used a different lengh shaft on many of their engine as well as different rotations etc. We can convert them to fit what ever engine you need by making a new lower end..
Thanks guys for the offers to help! Here are some pics. End of shaft to mounting surface of base measurements are as follows: 4" , 3 5/16" , 4 1/2". Thanks again!
Looks like you have what ever you would need. My notes here at the shop show... 392- at 4.5 inches 354- at 4.25 inches 241-264-270 at 3 7/8 Hot heads makes a sleeve to allow you to cut and make the shaft any length you wish. Its a piece of tubing and two roll pins, seems to work just fine, as the distributor really doesnt have any load. Now get the one you want to me and i will set er up , sell the other one to the other hemi dude.........
That is some real handy info -thank you! Just to make sure I measured correctly where are you supposed to measure from? Thanks
The Jalopy Journal
