Hello to everyone. I'm about to purchaser first 30 roadster body and frame this morning. This is a whole new thing to me. I don't know squat , but I'm very positive about the project. I was wondering if anyone knows a book or a thread I can follow with step by step instructions from frame to finsh. The car sits channeled mocked over frame right now. The guy said it's set up for a 350/350 combo. I have no experience in fabrication,welding etc . But have a friend that's a welder and is going to be helping me out. I wish I to put a flathead in it but sounds easier and cheaper to drop in a 350 with vintage ***esories.I appreciate all advice. Any feedback welcome!
Welcome from Michigan. Go to the main board and start searching. You'll find everything you need to know. This is an amazing site. Good luck.
theres a bajillion threads on those fords.. but if its allready set up for a 350 and what ever trans.. looks like alot of the fab work has been done. so should be an easy project for a beginner.. and welcome from AZ
Welcome from Scotland, and good luck with the project. If you get sick of it, pack it up and send it over to me. Gerry
hello everyone so far i find myself trying to decide to etheir try to bring it back to its original state or continuing to from where they left off. I either replace the doors and cowl or repair them.
The Jalopy Journal
