Just picked up this older Weiand air cleaner off FleeBay.......and curious. Did it originally fasten to the carb with the large radiator clamp??? If not, what was used.. Thanks much, Bob
What's the base look like? It may have had a flat center bar like the Edelbrock pro flows use to hold the base on the carb center stud and the lid would bolt to the base.
It probably just fits snug on the carb, if it doesnt, bend the ring in a little so it does. I had 2 on a tunnel ram that just pushed on the carbs with no attatching hardware.
Edelbroke is correct " may have had a flat center bar like the Edelbrock pro flows use to hold the base on the carb center stud and the lid would bolt to the base. " When Holley took over weiand they had dropped the Weiand and Holley made it till around 2008 when it was also discountinued Holley's part #120-147 Here is a link to a Holley 2008 catalog http://www.holley.com/data/Catalogs/Dress Up.pdf If I can find mine (holley) and if I can figure how to i'll try and post a pic of that attachment bar..
Hold everything! summit shows a pic of it here: http://www.summitracing.com/parts/HLY-120-147/?rtype=10 Hope that helps Steven
I have an air cleaner like the one shown in the picture purchased from ebay. What year was it made and current cost
Do an intro in the appropriate section if you expect to get any respect around this joint! http://www.jalopyjournal.com/forum/showthread.php?t=44274
'70s not worth squat unless you're a street beast enthusiast. Uh have we met? I see one post a question. Who are ya and what are you about?
The Jalopy Journal
