yah yah so i screwed up some where probably in the welding phase and got some warpage on the frame.. i measure everything at the end and i am out of square by 1 inch and an eighth ....what to do? option 1 take it to the frame shop where my buddy work and have it pulled... 2. drive it ?.... this is my dielema at the moment anybody go through anything like this before? and would the adjustments in the tie rods that are on the wishbones help or no? thanks again flop
Thats a lot of warpage. I'd see about getting it straightend. a t least +or - 1/8 " Or drive it and see how it is ?? Sparky
PAY NO ATTENTION to the measurement listed above it was to early and i read my notes wrong and typed the wrong measurement in. the frame is out just a hair more then a quarter of an inch sounds a little more reasonable then an 1 and an eighth doesnt it? so what are your opinions now ?
The Jalopy Journal
