Panel Weld Question

I need to replace a large section of a panel that I cannot access from the rear for clamps (1950 Chevy quarter). How do I fasten my patch in place for **** welding (torch)?
I'm thinking overlapping straps and sheet metal screws. Is this the best approach?
Thanks.

 

magnets

 

Maybe something like this might help.

http://www.jalopyjournal.com/forum/showthread.php?t=569265&highlight=welding+clamps

 

How about a thin piece of sheet metal, about the size of a quarter. Use a hacksaw to cut slots from two sides, leaving a narrow connecting piece right in the middle. Push it in the space between the two pieces you are welding, and rurn it 90 degrees. Remove it after you tack the patch on.

 

magnets or pop rivits

 

Hey there 'Mo...how'd you get on with this welding job? PB

 

Thanks for asking, fleet-master.
Mechanical problems played a trump, and bodywork is on hold.

And thanks for the suggestions, guys. I'll let you know how it works out.
(It may be a while. )

 

use clecos!! here is an example of how you can span **** joints in a nonaccess point

http://www.donshotrodpage.net/Project-57/Page033.html

later jim

 

Like jim said- cleco fastners, then run a body saw along the top edge of the panel. Good luck

 

................