U-joint help needed!!

Hey everyone. Had a quick question hopefully someone has an answer for. I'm putting a Richmond street 5 in my 59 el camino. The transmission uses a turbo 400 yoke. I have a yoke just not sure what model car it's from. I need to get a conversion u-joint to adapt it to my factory 59 driveshaft.

Anyone have any part numbers or specs on what I should get?

Are all the turbo400 yokes the same as far as the joint they accept?

Many thanks in advance

Cody

 

A good NAPA store will set you up right quick.

 

not the same, some inside snap ,some outside, snap some 30 series joints,,,

 

Ok good to know. I just dropped the yoke off at out parts suppliers so he can match something up. Hopefully he knows what he's doing. I do know this much. The yoke was the one with the plastic retainers you have to melt out. Therefore it needs the inside clips.