measurement needed model a door handle door

Need asap I know you guys rock.Im installing the door handles today and need approx stock center 29 ford

 

I'm not exactly sure what you're asking. Interior or exterior handle?

 

Exterior door handle

 

Need the center of the shaft roadster door ,Coupe might be the same,Im on a mission to hang stuff ,

 

Sorry man, I still don't understand what you want measured.

 

I have to drill a hole in my door to mount exterior handle ,I need the measurement down from top of door and from the side ,As close to center of shaft as possible for exterior door handle shaft

 

On my coupe it's 3 1/2" down and 1 1/2 from the side. Hope that helps. It's approximately 15/16" diameter and the mounting hole are 1 1/2" apart.
Hope that helps.

 

If you have a roadster you will be best to have measurements from a similar door to be sure.
Closed car doors are so much different visually so there maybe other differences.
I am sure somebody out there would have a door or a car they could measure off.
I have a door, but I am not home right now.

 

Roadster doors are roughly 4 " shorter than a coupe door . Why not put the latch in and sharpen up an old rod and mark it from the inside.

 

Not using stock latches ,Bear claws ,Gl*** car ..............

 

You may try calling Brattons they may know if you don't get the info on here

 

here is a photo, perhaps this helps

 

Done ,Thanks chemin Your measurements got me in the ballpark ,I modified the measurements .........

Im also determined to make it look like a steel car to the eye ........