Hey guys, I just got a new book called "Full Bore Sheet Metal" by Mark Prosser & Bryan Fuller (yes the Bryan Fuller from Fuller Hot Rods & 2 guys Garage). This book is a must have for novice and old farts, it talks about everthing from hand tools to sheet metal selection, from hammer forms to welding, it's great book. I got mine yesterday and have read almost the entire book already, Prosser's writing style is more than just informative it's entertaining so it's not dull and boring like most how-to books. No, I don't have any investment and I am not getting paid for this, I just think it is a very helpful and entertaining book. I teach collision repair and hot rod fabrication at a state tech school here in GA and we will ad it to our suggested reading list. Have a great week all, the coupeman36.
Found it on Fuller's website and it looks interestng. http://www.fullerhotrods.com/pages/index.aspx So far it isn't on Amazon at the moment and Barnes & Noble shows it but it isn't in stock. Looks like a good addition to the metal pounding book collection.
I have to repair some rust in some floor pans,Does the book cover how to make a pattern,ga of meta,l wire size for mig ect ? .........Thanks...................YG
The Jalopy Journal
