1958 Dodge pickup

Hello to all. New to the H.A.M.B. I read some info here, from a couple years back, about doing Volare suspension conversions on older 50's Dodge trucks.
I recently purchased a 1958 Dodge 1/2 ton pickup. Originally a 315 RedRam V8/4 speed truck (these drivtrain parts and the original axles are for sale if anyone intrested). I am going to update all the suspension, as well as the engine/trans to make it more enjoyable to drive and drop her down in the weeds.
I intend to do this coversion myself, as I am a certified welder/fabricator. Already have my donor car, a slant 6/auto 1980 Aspen. The truck will end up with a fresh built LA 318/a833 4speed combo (gear jamming only way to go), and a slightly narrrowed, 4 link, airbagged, 3.55 suregrip 8 3/4 when I am done.
Been doing some internet research and have found templates that are Ford specific, but none for my Dodge. I also understand that my frame rails are a little narrow at the front, causing some interference issues with the streeing box.
I gave some consideration to other suspension options, but I have been a MOPAR guy for 30 years. Sticking with the Chrysler parts.
Anyone with any new info and/or pictures of this swap would be greatly apprecited. Thanks.

 

Welcome to the HAMB Wags..However,,you have posted this in the INTRODUCTION forum..Read the "STICKY" at the top of this page....INTRODUCE YOURSELF>>Then post your qusetions and photos on the Main messgae board..lot more viewers there

 

Thank you wbrw32 I realize my mistake now. I have entered my intro info in the correct area. Can I remove this tech info and repost in the HAMB main message section?

 

Just let it ride...it will finally end up many pages down

 

I might be able to help,ive got a 63 dodge townpanel with a L shaped torsin bar (2 of them) I can get picks,motors out, set up for La 318 an 904 . Realy ****y job but could give you some ideas.Iwas going to redue it but the wheel base is off 1 1/2 inch on driver side.Pm is the best way to get me.Also take about a week for pics.......YG





9

 

Hey thanks for response. Look forward to seeing what you've got.

 

welcome waggs

 

Hi: I am interested in the original drive trane from the 58 Dodge truck.
Bob 203-265-2530
bobmaredon@sbcglobal.net
Please email me or call. I am new at HAMB and not sure how to get reply.