Register now to get rid of these ads!

New from colorado

Discussion in 'New to the H.A.M.B.? Introduce yourself here!' started by Portell, Oct 17, 2011.

  1. Portell
    Joined: Oct 16, 2011
    Posts: 3

    Portell
    Member

    I have been browsing the site for advise for a little while now, and its been helpful. So its about time to start showing off my projects so I finally signed up.

    Oh and I am working on a 1966 Charger with the old wide block 318 and 1955 international R100 with everything restoring to about 95% original.
     
  2. Just Gadget
    Joined: Aug 7, 2011
    Posts: 1,130

    Just Gadget
    Member

    we are about sharing here ... not bragging or showing off ! Just my opinion!
     
  3. damagedduck
    Joined: Jun 16, 2011
    Posts: 2,341

    damagedduck
    Member
    from Greeley Co

    welcome from Greeley Co,--chuck
    there a few Coloradans around here,where are ya?
    put it in your location,you might find a new buddy..
     
  4. e1956v
    Joined: Sep 29, 2009
    Posts: 2,445

    e1956v
    Alliance Vendor

    Welcome from the Springs
     
  5. MTRodder
    Joined: Sep 17, 2011
    Posts: 16

    MTRodder
    Member
    from Laurel, MT

    Welcome from Montana.
     
  6. Portell
    Joined: Oct 16, 2011
    Posts: 3

    Portell
    Member

    Thanks everyone from Colorado, I am loving old cars from this part of the country, everything I have seen is rust free.
     
  7. Hello and welcome from central Iowa!
     
  8. Welcome from Trinidad.

    Lee
     
  9. welcome from va
     
  10. Portell
    Joined: Oct 16, 2011
    Posts: 3

    Portell
    Member

    Thanks everyone, I find it hard to post on this site, am I doing something wrong? I have a few questions about my engine since its in my muscle car but it was used in the 50s and only one year in my car. Thanks
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.