new to H.A.M.B

I guys just signed up hope i can get some good info from you guys.FIRST question i have is that i have a 1962 ford econoline with a 170 cid eng i need a carburetor real bad i have looked all over the web and i can not find one anyone know wheir i can get one or will a 200cid motor fit in my econoline please let me know if any one had this same problem thanks bullet

 

this won't end well.

 

This is the introduction page. Read the sticky at the top, do a proper intro, and then post your questions on the general discussion page.

 

just leave now before they tear you apart. they are vicious to the new ones. Go to Daytona's Turkey Trot swap meet next week, biggest swap/show in Florida at the Speedway.....don't bother these jamokes

 

I dont want to get a new one ripped. I got some sources. Pm me

 

wrote wrong thing on wrong page

 

ok guys new to the h.a.m.b live here in florida on the space coast for the ones that dont know its location is on the east coast.MY first car i did was a 1938 studabaker hump back did it from ground up for doing my first car came out real nice.DID a seventy nova with my son with a 454 big block and a old school four speed trans. now i have a 62 ford econoline pu witch i will keep all stock.LOVE the old cars and working on them hope to make new friends here my name is dominick and thanks again stud38 ps going to the turkey rod run on sat to look for parts allso good one on the jamokes