where to buy splined shafts

anyone know where I can look for fully splined shaft stock? I am in need of a piece of 6 spline X 1.125" OD X 12" long fully splined stock. all the stock I find on the internet is precut to 8" or less? someone must produce longer lengths or maybe one of you know where I can salvage the same size stock from an old tran,vehicale or farm equipment?

Paul

 

Steering shaft from a semi truck?

 

I would try Mark Williams ent. I bet they could make any shaft and spline. Lippy

 

Look at sprint car or midget driveshafts.

 

Try Gary Schroeder, he was real helpful when I needed a short driveshaft. Same folks who make the steering gear.

 

One end splined 12"
http://www.baumhydraulics.com/product.php?productid=27089&cat=0&page=2
fully splined 10"
http://www.grainger.com/Grainger/HUB-CITY-Splined-Shaft-15V713?Pid=search
Call Bearings and Drives

 

hub city shows 10 inch. I'd contact them to see if they can make a longer one to order. http://catalogs.hubcityinc.com/farmrev/splinedshafts.html

 

Go with a HAMBer, Da' Bomb made a new steering shaft for me...............
http://www.jalopyjournal.com/forum/showthread.php?t=615086

 

Good to know about Da'Bomb I need a piece made for my dragster Thanks

 

thanks for the info, I also found a few comapanies that deal with hydrolics & PTO's that sell the full splined shaft at 10", unfortunatly I need 11.125" for my final size. I will email them and see if they can do a 12" cut?
Paul