Register now to get rid of these ads!

Anybody with a 51 Ford Victoria??

Discussion in 'The Hokey Ass Message Board' started by slddnmatt, Nov 29, 2012.

  1. slddnmatt
    Joined: Mar 30, 2006
    Posts: 3,685

    slddnmatt
    Member

    anybody out there with a 51 vicky? i need a measurement of the length of the doors, and the stainless trim piece that caps the top of the upper 1/4 panels, unless it curves all the way around the roof and meets in the middle.. I wasn't sure if the vicky doors were the same length as the sedans..

    thanks
    Matt
     
  2. Chris
    Joined: Jan 5, 2005
    Posts: 14,500

    Chris
    Member

    PM Royalshifter
     
  3. magoo
    Joined: Jun 6, 2002
    Posts: 214

    magoo
    Member

  4. 50Fraud
    Joined: May 6, 2001
    Posts: 10,099

    50Fraud
    Member Emeritus

    I'll go measure them in the morning.
     
  5. Dean Lowe
    Joined: May 20, 2008
    Posts: 22,029

    Dean Lowe
    ALLIANCE MEMBER

    Yes, Tony, it should be the same on your '50 Vicky. ;)


    [​IMG]
     
  6. Mr48chev
    Joined: Dec 28, 2007
    Posts: 35,835

    Mr48chev
    ALLIANCE MEMBER

    That's a rare one Dean, one of one? It does make a better looking car in my estimation though and I had a 51 when I was 15.
     
  7. 50Fraud
    Joined: May 6, 2001
    Posts: 10,099

    50Fraud
    Member Emeritus

    Dean is kidding; my car really is a '51 disguised as a '50.

    The maximum length of the door is 46 5/8", measured a few inches above the stainless side trim.

    The trim at the base of the quarter window is 24 1/4". It ends where the rain gutter touches down on the quarter, and the trim is angled at both ends. A second piece of trim continues straight back about 12", and then gradually sweeps around the rear window until it meets its mate in the middle of the deck.
     
  8. The bottom edge of the door trim is 42-1/4" long and tapers in on both ends. If your going to Hard top a Coupe you will also need the windshield post. I think I could help you out with that.
    The Wizzard
     

    Attached Files:

  9. slddnmatt
    Joined: Mar 30, 2006
    Posts: 3,685

    slddnmatt
    Member

    cool thanks guys, i forgot to ask what the length of the upper door stainless trim is also, if you could please..
     
  10. That's the 42-1/4" I posted
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.