1955, 1956 and 1957 all used different wire looms. I have the original for my '55, but they werent installed for me to see specifically which bracket goes where, I found them in a coffee can in the trunk. One is much longer than the others. Can someone show or describe to me exactly where each of them installs? I've got the brackets under the manifolds under control, don't worry about those FYI- I'm sure I could find the info on TriFive but for some reason my IT department has limited my message board/forum access categories to machining, traditional hot rods and spoiled maltese dogs.
I also want to thank everyone for not breaking my balls every time I start a thread about something so minor. I appreciate HAMB advice. I guess I'm not the only one that suffers from OCD around here.
Not a quick wire change and would bet most of the parts would have gotten thrown out on many of those motors and you are lucky to have them,the Ford y block I will be building has a similar setup so those type of looms require good quality wires as it would get old to change them every year.
The Jalopy Journal
