Am getting close to fire up on my motor and am going to run a 600 holley double pumper on my 292 any suggestions on inital jetting or any experience on these motors. stock appears to range 64-66 and 74 to 76 for this carb am going to start with that Any suggestions or ideas ?
Most 600 holleys I have seen where 66 out of the box and Holley generally jets on the rich side. I would start there. That is on a vacuum secondary
It should be a good starting point not much different in jetting than a 300 hp small block i would think. hope to have it fired up next weekend
The Jalopy Journal
